Where to get the pins for BetaCrafts track plating?
Posted: Mon Jan 11, 2010 9:21 am
Hi again,
I was browsing some sites for the challenger plans more and found a picture of the track with pins used to join the track together for alignment. I had ordered and received 4 pieces of the track and it has two holes on each end but no pins. Their site does not show these pins forsale. I assume I can just try going to a hardware store and getting something that will match that size. Has anyone else does this? Below is a picture on the web site of the track with the pins sticking out the end:
Thanks!!
I was browsing some sites for the challenger plans more and found a picture of the track with pins used to join the track together for alignment. I had ordered and received 4 pieces of the track and it has two holes on each end but no pins. Their site does not show these pins forsale. I assume I can just try going to a hardware store and getting something that will match that size. Has anyone else does this? Below is a picture on the web site of the track with the pins sticking out the end:
Thanks!!