I ran a race with 40+ cars. I ran the race with auto timer reset. Everything went fine. After completing all the heats I started to set up for a championship run. Using the top three from each subgroup and the software gave me an error stating previous heats were not complete. Timer reset by itself during the race. Time transmitted all time and in correct sequence
What would cause this and how correct or avoid it in the future?
Gate is The Champ and using Verizon 16
Incomplete heats
-
- Apprentice
- Posts: 1
- Joined: Sun Mar 18, 2018 2:29 pm
- Location: Henderson NV
- gpraceman
- Site Admin
- Posts: 4926
- Joined: Fri Jun 20, 2003 12:46 am
- Location: Highlands Ranch, CO
- Contact:
Re: Incomplete heats
If you go to the Racing tab of the Main screen, select the race group in question, then on the right select "Not Completed" under Show Heat Results, are any heats listed? The only time you should get that warning is if you somehow skipped a heat(s).
Randy Lisano
Romans 5:8
Awana Grand Prix and Pinewood Derby racing - Where a child, an adult and a small block of wood combine for a lot of fun and memories.
Romans 5:8
Awana Grand Prix and Pinewood Derby racing - Where a child, an adult and a small block of wood combine for a lot of fun and memories.